"A-LEE-SAM"

#OT-1S only $38.99!

 For those interested in making their own ornamental Rose engine lathe from the various plans on the internet, (or the MDF Rose Engine project published in the Spring 2007 issue of the American Woodturner. The article complements the MDF Rose Engine Construction Instructions document posted on the AAW website). See also the Ornamental turners website at: http://www.turners.org/oti.htm 

This pre-made spindle will help you along! It is made from polished 1 inch OD steel 14 inches long. One end is threaded 1 X 8 threads per inch. With about 1 inch of thread beyond shoulder. The other end has a 2 inch long flat milled on the side to aid in holding a set screw. This version has a milled-while-on-spindle, (for accuracy), removable shoulder to tighten your chuck or faceplate up against. This shoulder incorporates "flats" to enable easier chuck removal!

No need to find a local machinist to  custom make one for you,  (one customer told us he was quoted over $100 to make the same spindle)!

OR

#DCB-01 only $29.99!

This pre-made spindled chuck backplate will help you along too! It is made from 12L steel and is 2 inches long. Spindle end is threaded 1 X 8 threads per inch, (1 1/2 inches of threads). The 2 inch diameter X 1/2 inch thick backplate is drilled and countersunk for 3 #8 woodscrews, (not included). Attach this to any material that can accept wood screws successfully and screw on your chuck, faceplate or a spindle mounted Jacobs drill chuck! Great for offset turning!

We also have a limited number of these backplates with a precision 1.00 inch stud opposite the threaded spindle to be secured in your 1.0 inch collet chuck, (5C etc.). See picture below, item #DCB-011!

   $34.99